How to minimize weld defects by the improvement in electrode angles

In welding we encounter a number of weld defects that need to be eliminated or we are in an attempt to minimize them within an acceptable range. One of the basic techniques to minimize these defects, is the right control of electrode angles. Now you need to know what are electrode angles in arc welding? Normally there are two angles that a welder should know. If one gains the proper familiarity with these angles, one can be successful in achieving quality welds by eliminating the following defects; 

1. Tilt Angle

The angle made by the either side of electrode (one of the two) with the plate surface. This angle is shown in the figure, called the tilt angle.
In order to achieve sound level of penetration, control of tilt angle is required. If we displace the electrode from the correct position, the weld will not be deposited equally to either sides of the joint. For example as shown in figure; If the electrode is displaced from the center line of the joint the weld metal will only be deposited on one side of line, which results in lack of side wall fusion, unweld edges and low strength weld deposit. Tilt angle is quite beneficial in multi-pass welding (temper bead process) where it is desired to make a weld pass on the specific part of joint or previous weld pass.

2. Slope Angle

The angle made by the electrode with the plate surface in the direction of travel. Sometimes it is referred to as  'lead angle'.
As it is stated earlier, the proper knowledge of controlling the electrode angle, leads one to achieve sound weld deposits. We know flux coating on electrodes are used to form slag that protects the weld deposit from any contamination in atmosphere. Slag formation also facilitates solidification of molten weldment and provides protection even after solidification. Now come to the point, the flow of molten slag is controlled by slope angle of the electrode. If the electrode approaches to vertical (90 degree), the molten slag will move into the weld pool and create the blockage between the electrode and plate. This will lead to a cause of many weld defects like slag inclusion, lack of fusion and lack of penetration etc. These defects are common in arc welding types MMA (stick welding), MIG where flux coated electrodes and flux cored wires are used respectively. So the right travel of electrode with correct lead angle can minimize these imperfections.

Oxyfuel Welding
Now there are some angles in oxyfuel welding that need to be acquainted with. Normally there are two techniques which are utilized in case of gas welding. Following are the primary concerns about these techniques

  • Torch angle 
  • Filler wire angle 
  • Direction of movement.

1. Forehand Technique


In this technique the torch moves in the direction of welding, making the angle of 60-70 degree with the weld deposit as shown in figure. In the figure you will see the filler rod is leading the torch making the angle of 30-40 with the joint.

2. Backhand Technique



In this technique the torch and filler travels in such a way that torch is leading the filler wire making an angel of 45-50 degree with the unweld section.

Comments

  1. This comment has been removed by a blog administrator.

    ReplyDelete
  2. Parag Traders in early 1980 in the GIDC of Vatva, Ahmedabad by Mr. Parag Mashruwala. We commence our business with the focus to cater to the requirement of Welding Electrodes, Equipments and Accessories to various industries specializing in Fabrication, Machine Shop, Forging and Castings in Ahmedabad.

    Welding Electrodes in India | Welding Electrodes Dealers in India

    Welding Equipments Dealer in india | Welding Machine in India

    ReplyDelete

Post a Comment